You are here: Home / JETEX 100 / DARTEX

Advanced Plan Search
User Panel


Log me on automatically next visit?

» Forgot password

 New Users

» Click here to Register!
Random Plan


 Plans with Great Build Guides

 »  HAWKER P-1081





Wing span: 22 Inches
Designed By: K. Brown
Description: COMMENCE by laying out the outline of the wing directly over the plan, using 1/16 in sheet medium balsa for both leading and trailing edges Cut out the 1/8 in sheet motor mount from hard balsa, and pin down in position over the plan, then cement in position the centre rib (R1). Cut and fit two pieces of 1/4 in x 1/8 in hard balsa, cementing them one on each side of R1, on top of the motor mount.

Next, cut and cement in place all the under surfaces of the ribs, using 1/16 x 3/32 in medium balsa. The ends of these strips are butt-jointed to the leading and trailing edges. Cut out the spars, A, B and C from medium hard balsa, and cement in place on top of the 3/32 in strips. Whilst these are drying, cut out the strips for the upper surfaces of the ribs, using soft balsa. Cut these to length, not forgetting to allow for the excess length caused by the curvature of the ribs.

Now start at the centre and work outwards towards the tips, cementing to the leading edge only. Having completed one half of the wing, do the same for the other half. Make sure that the joints are properly dry before proceeding further. Now start at the centre again, and bend over each strip, cementing at the spar junctions, and finally cement to the trailing edge. It may be found necessary to steam the strip used for the extreme tip rib, although this ran be overcome by using a softer grade of balsa.

Fuselage. With the wing still pinned down to the building board, cut out the fuselage horizontal crutch from 1/16 in medium balsa sheet, and cement to the leading edge. Do the same with the upper half of the fuselage vertical crutch. Make and fit the front bulkhead..."at they are quite vertical.
Keywords: dartex jetex 100 k brown
Hits: 4016
Downloads: 5
Rating: 0.00 (0 Vote(s))

Previous plans:
 Next plan: