Advanced search
Registered users
Username:

Password:

Log me on automatically next visit?

» Forgot password
» Registration
 
Random image

SEA DART
SEA DART

nitrocharged


HAWKER HUNTER
HAWKER HUNTER

            

HAWKER HUNTER
Description: Reprinted from Eagle Annual 3, 1952

This Jetex 50 powered flying model of the famous Hawker Hunter takes just a single evening to build. Start by tracing the parts on to sheet balsa and then cut them out with a sharp razor blade – using a ruler as a guide for the straight cuts. The cockpit, R.A.F. markings and control surface outlines may be marked on the wood with coloured ball-point pens before the model is assembled. Round off the fuselage corners with sandpaper (except at tailplane position) and cement a 1" × ¼" × ¹/8" piece of hardwood to one side (see front and side views). Cement asbestos paper – contained in Jetex 50 outfit – to the other side and screw the motor clip in position.

Round off the edges of the flying surfaces (except wing and fin roots). Sand wing roots to slight angle and cement together – pinning one panel down flat and packing up the other 1 ¼" at the tip. When dry, slide wing into slot in fuselage and well cement, after carefully checking for correct alignment. Add small ‘X’ fairing pieces. Now cement tailplane to fuselage, followed by fin. Push a pin into the fuselage as indicated, attach the loaded motor and check that the model balances level. Drawing pins may be pushed into the nose or tail to obtain correct balance.

Glide test the model on a calm day – gently launching from shoulder height and noting if it dives or ‘stalls’. Correct a nose dive by removing weight from the nose or adding it to the tail. If the model’s nose rises abruptly and then falls (stalling), add more nose weight. A turn in either direction is required, but if the model turns too sharply correct by pushing a drawing pin into the wing tip on the outside of the turn. When satisfied with the glide, ignite the charge, wait several seconds for thrust to develop, then launch on an even keel. Choose a space clear of trees and buildings as the model is capable of long duration flights of up to a quarter of a mile.
Keywords: bill dean hawker hunter jetex 60
Date: 03.01.2021 02:41
Hits: 2538
Downloads: 10
Rating: 0.00 (0 Vote(s))
File size: 30.5 KB
Added by: nitrocharged



Previous image:
   GRUMMAN F9F-5 PANTHER  
 Next image:
HAWKER HUNTER